Car Battery Reconditioning Tips That Really Work

Published On June 15, 2019 | By Charles Sorrell | Technology

If you have a car you will surely be familiar with how important its battery is. A car battery is the lifeline of a car. If it fails to hold a charge or you have to jumpstart it, you will get into great distress and your car will be a piece of junk without it. So the best thing you can do is to take good care of your car battery to avoid an embarrassment while on the way to your destination. Here are a few tips that really work and will keep your car battery in good condition so that it may last longer:

Keep Your Car Cables Clean:

Sometimes corrosion layers get accumulated on and around the car battery that makes it highly volatile. First, you need to clean the corrosion from the battery and then on and around the cables of the battery. It will make the flow of the current easy. A tablespoon of baking soda, a cup of water and non-metallic brush will do the job. With this, you can clean every part of the top of the battery gently.

Check the Level of Water in The Battery:

Gently remove the battery covers and pour distilled water in the battery. Make sure the water is not overfilled and it is poured inside the battery securely.  Wait for the water to reach the end of the refill hole. Never try to overfill into the fill holes.

Check the Charge & Condition of the Battery:

For this, you should test the electrolyte in each cell. You squeeze the ball and draw the solution in the battery tester. Then hold the tester with much care and record the reading on a paper. You then squirt the solution back into the small cell. The testers are calibrated assuming a battery is at 80 degrees F. You add .04 to each reading for 10 degrees above 80 and subtract .04 for every 10 degrees below. A battery that is fully charged should have a reading of 1.265 or higher. If all the readings show fair or low (as 1.200 is low if you get it) but are stable, you need to recharge the battery.

Clean The Battery Terminals With A Wire Brush:

After a few months, acid build-ups can be seen on the battery terminals. These acid build ups are very pernicious for the battery life and can erode it secretively. So after every 4-6 months, inspect your battery for these type of acid build-ups and remove them with a wire brush scrub after applying a gentle scrub. Then bathe these terminals with the mixture of baking soda and distilled water. This type of solution will clean the terminals of acid remnants. After this, apply grease to protect the battery terminals from corrosion and rust.

These simple tips can enhance the battery life and also add to your savings as you will not have to buy a new battery frequently. If you want to learn how to recondition a battery and use it again as a new one you should invest in EZ battery reconditioning course. This course is info packed and has helped thousands of DIY type of guys and preppers alike recondition old batteries.

Like this Article? Share it!